It is important to determine the ultimate properties of materials to be able to understand the performance range of products and the reasonable expectations for establishing operating ranges.

Approaches

We perform testing of high extension rubber materials using our laser extensiometer.

The flexural strength of rigid unsaturated polyester cure in place pipe (CiPP) sections are routinely tested using our three point bend fixture.

Specialized stress tests can be configured.  For example, we have performed stress testing of bioabsorbable screws in a cyclic compression mode while immersed in saline at elevated temperature, this was a product-specific custom stress test.

Stress testing is a method of evaluation that requires a fairly large amount of sample.  For flex testing, for example, the test specimens may be an eighth inch thick, an inch wide, and six inches long. Total sample mass of 1 to 5-lbs is reasonably typical.

Some specimens are required to set the instrument parameters and then five to seven replicates are required to obtain a complete data set. 

Pellets need to be converted to slabs, sheets, or molded.   

Our scientists can discuss specialized sample prep with you, contact us to get the discussion started.

Experience

Products we’ve tested:

• Cure in place pipes
• Fibers
• Rubber products
• Bioabsorbable screws
• Sporting goods products